Programming .ekp file and encrypted pof file, Integrate the .ekp into .pof programming, Programming .ekp file and encrypted pof file -14 – Altera MAX 10 FPGA User Manual
Page 44
• JEDEC STAPL Format (
.jam
)
• Jam STAPL Byte Code (
.jbc
)
• Serial Vector Format (
.svf
)
10.Type the file name in the File name field, or browse to and select the file.
11.Click OK to generate the
.jam
,
.jbc
or
.svf
file.
Programming .ekp File and Encrypted POF File
There are two methods to program the encrypted
.pof
and
.ekp
file:
• Program the
.ekp
and
.pof
separately.
• Integrate the
.ekp
into
.pof
and program both altogether.
Programming .ekp File and Encrypted .pof Separately
To program the
.ekp
and encrypted
.pof
separately using the Quartus II software, follow these steps:
1. In the Quartus II Programmer, under the Mode list, select JTAG as the programming mode.
2. Click Hardware Setup and the Hardware Setup dialog box will appear.
3. Select USBBlaster as the programming hardware in the Currently selected hardware list and click
Done.
4. Click Add File and the Select Programmer File dialog box will appear.
5. Type
in the File name field and click Open.
6. Select the
.ekp
file you added and click Program/Configure.
7. Click Start to program the key.
Note: The Quartus II software message window provides information about the success or failure of
the key programming operation. Once the
.ekp
is programmed,
.pof
can be programmed
separately. To retain the security key in the internal flash that had been programmed through
the
.ekp
, continue with the following steps.
8. Select the
.ekp
to be programmed to the selected device.
9. Check only the functional block that need to be updated at child level. Do not check operation at the
parent level when using Programmer GUI.
10.After all settings are set, click Start to start programming.
Integrate the .ekp into .pof Programming
To integrate the
.ekp
into
.pof
and program both altogether using the Quartus II software, follow these
steps:
1. In the Quartus II Programmer, under the Mode list, select JTAG as the programming mode.
2. Click Hardware Setup and the Hardware Setup dialog box will appear.
3. Select USBBlaster as the programming hardware in the Currently selected hardware list and click
Done.
4. Click the Auto Detect button on the left pane.
5. Select the
.pof
you wish to program to the device.
6. Select the
,
right click
and select Add EKP File to integrate
.ekp
file with the
.pof
file.
3-14
Programming .ekp File and Encrypted POF File
UG-M10CONFIG
2015.05.04
Altera Corporation
MAX 10 FPGA Configuration Design Guidelines