Programming .pof into internal flash, Programming .pof into internal flash -7 – Altera MAX 10 FPGA User Manual
Page 37
Note: The JTAG Secure feature will be disabled by default in Quartus II. If you are interested in
using the JTAG Secure feature, contact Altera for support.
Caution:
MAX 10 FPGA device would become permanently locked if user enabled JTAG secure
mode in the POF file and POF is encrypted with the wrong key.
f. Verify Protect.
g. Allow encrypted POF only.
h. Watchdog timer for dual configuration and watching value (Enabled after adding 2
.sof
page with 2
design that compiled with Dual Compressed Internal Images).
i. User Flash Memory settings.
5. In the File name box, specify the file name for the programming file you want to create.
6. To generate a Memory Map File (
.map
), turn on Create Memory Map File (Auto generate
output_file.map). The .map contains the address of the CFM and UFM with the ICB setting that you
set through the Option/Boot Info option.
7. To generate a Raw Programming Data (
.rpd
), turn on Create config data RPD (Generate
output_file_auto.rpd).
With the help of Memory Map File, you can identify the data of each functional block easily. You can
also extract the flash data for third party programming tool or update the configuration or user data
through Altera On-Chip Flash IP.
8. The
.sof
can be added through Input files to convert list and you can add up to two
.sof
files.
For remote system upgrade purpose, you can retain the original page 0 data in the
.pof
, and replaces
page 1 data with new
.sof
file. To perform this, user need to add the
.pof
file in page 0, then add
.sof
page, then add the new
.sof
file to page 1.
9. After all settings are set, click Generate to generate related programming file.
Related Information
Provides more information about Altera On-Chip Flash IP Core.
Programming .pof into Internal Flash
You can use the Quartus II Programmer to program the
.pof
into the CFM through JTAG interface. The
Quartus II Programmer also allows you to program the UFM part of the internal flash.
To program the
.pof
into the flash, follow these steps:
1. In the Programmer window, click Hardware Setup and select USB Blaster.
2. In the Mode list, select JTAG.
3. Click Auto Detect button on the left pane.
4. Select the device to be programmed, and click Add File.
5. Select the
.pof
to be programmed to the selected device.
6. There are several options in programming the internal flash:
UG-M10CONFIG
2015.05.04
Programming .pof into Internal Flash
3-7
MAX 10 FPGA Configuration Design Guidelines
Altera Corporation