Dialogic DSI SPCI Network Interface Boards - Manual (Page 99)

Dialogic ® DSI SPCI Network Interface Boards Programmer's Manual Issue 5
99
The link’s unique logical link identity. It must be in the range 0 to one less
than the total number of signaling links supported.
The logical identity of the link set to which the link belongs. The linkset must
already have been configured using the MTP_LINKSET command.
The logical identity within the link set of the signaling link. It must be in the
range 0 to one less than the number of links in the link set.
The signaling link code for the signaling link. This must be unique within the
link set and is usually the same as the . The valid range is 0…15.
The board id of the signaling processor allocated for this signaling link.
The index of the signaling processor (within the board) allocated for this
signaling link. It must be in the range 0 to one less than the number of
signaling processors on the board.
When is set to a non-zero value, the parameter is the
logical identity of the T1/E1 line interface (liu_id) containing the signaling link
It must be in the range 0 to one less than the number of line interfaces.
Note: For the SPCI2S, stream identifiers for the PCM interfaces are implemented on
streams 2 and 3.
The timeslot used for signaling in the range 1 ... 31. For an E1 interface the
valid range is 1 ... 31. For a T1 interface the valid range is 1 ... 24. When set
to zero the signaling path through the board must be set up manually using
the switch control messages.
A 16 bit value containing additional run-time options.
Bit 0 is set to 1 to force the use of the emergency proving period during link
alignment or zero to use the appropriate proving period according to the
MTP3 recommendations.
Bit 1 is set to 1 to cause a signaling link test (in accordance with ITU-T Q.707
/ ANSI T1.111.7) to be carried out before a link is put into service, or zero if
a test is not required.