Dialogic DSI SPCI Network Interface Boards - Manual (Page 62)

6 Message Reference
62
Parameter Description:
state
The current state of the LIU from the following table:
State Description
0 OK
1 PCM Loss
2 AIS
3 Sync Loss
4 Remote Alarm
Status Response
The confirmation message (if requested) indicates success by status of zero.
On error, the following status values can be found in the confirmation
message.
Value Mnemonic Description
0x01 None Invalid framer ID.
0xff None Invalid message length.
6.3.6 LIU CT bus Initialization Request
Synopsis:
This message is sent to the board at initialization time to set up a static
switch path through the board between the Line Interface Unit (LIU) and the
CT bus. It connects selected incoming voice timeslots from a T1/E1 LIU to a
sequential block of channels on the CT bus and prepares the outgoing
timeslots for subsequent use by the MVD_MSG_SC_LISTEN message.
Note: When using s7_mgt, this message is generated by s7_mgt as a result of the
LIU_SC_DRIVE command. It therefore does not need be generated by the user.