Dialogic DSI SPCI Network Interface Boards - Manual (Page 103)

Dialogic ® DSI SPCI Network Interface Boards Programmer's Manual Issue 5
103
The maximum number of ISUP circuit groups that the user intends to use.
This must not exceed the maximum number of circuit groups supported
otherwise module configuration will fail. Typically would be set
to the maximum number of circuit groups supported.
The maximum number of ISUP circuits that the user intends to use. This must
not exceed the maximum number of circuits supported otherwise module
configuration will fail. Typically is set to 32 times the number of
groups for E1 operation and 24 times the number of circuit groups for T1
operation.
Note: The valid range for the circuit identifier (cid) is from zero up to one less than the
maximum number of circuits (num_ccts).
Optional parameter for use when operating in dual resilient configuration.
This parameter is the module_id of the ‘partner’ ISUP module (equivalent to
the ‘module_id field in the ISUP Configure Request message as documented
in the ISUP Programmer’s Manual).
7.3.2 ISUP Circuit Group Configuration
Syntax: ISUP_CFG_CCTGRP
Example: ISUP_CFG_CCTGRP 0 3 1 1 0x7fff7fff 0x00000003 0 0x2d
2 0x8 4 0x00000000
The configuration parameters for a group of ISUP circuits. Usually a group is
all the circuits on a single E1 or T1 interface.
The group id of the circuit group in the range 0 to one less than the number
of groups supported.
The destination point code for all circuits in the circuit group.
The Circuit Identification Code (CIC) that is allocated to the first circuit in the
circuit group.
The logical id for the first circuit in the circuit group. It must lie in the range 0
to one less than the number of circuits supported.