Dialogic DSI SPCI Network Interface Boards - Manual (Page 57)

Dialogic ® DSI SPCI Network Interface Boards Programmer's Manual Issue 5
57
6.3.2 LIU Control Request
Synopsis:
Message sent by the application to dynamically control operation for a Line
Interface Unit (LIU). Allows setting of outgoing alarms and diagnostic
loopbacks.
Message Format:
MESSAGE HEADER
Field Name Meaning
type LIU_MSG_CONTROL (0x7e35)
id liu_id
src Sending Module ID
dst MVD_TASK_ID (0x10)
rsp_req used to request a confirmation
hclass 0
status Status Response (if confirmation requested)
err_info 0
len 16
PARAMETER AREA
Offset Size Name
0 1 ais_gen
1 1 rai_gen
2 1 loop_mode
3 13 Reserved for future use, must be set to zero.
Description:
This message is sent to the DSI SPCI Board to perform dynamic changes to
the operation of the Line Interface Unit. It allows the user to control
generation of AIS (Blue alarm) and RAI (Yellow alarm) and to activate various
diagnostic loopback modes.
The confirmation message (if requested) indicates success by status of zero.
Parameter Description:
ais_gen
The mode used to generate the Alarm Indication Signal (Blue Alarm) taken
from the following table: