Zoom R16 - Manual (Page 80)

R16 eff
ect types and parameter
s
79
R16 effect types and parameters 1
Type Parameters/Descriptions
Compressor
Sense Attack Tone Level
MXR Dynacomp type compressor.
Rack Comp
Threshold Ratio Attack Level
Compressor with more detailed adjustments.
Limiter
Threshold Ratio Release Level
Limiter for suppressing signal peaks above a certain level.
Effect parameters
Insert effect
CLEAN, DISTORTION, ACO/BASS SIM algorithms
COMP/LIMITER module
Parameter
name
Setting range Description
Sense 0~10 Adjusts compressor sensitivity.
Attack
Compressor: Fast, Slow Selects compressor response speed.
Rack Comp: 1~10 Adjusts compressor response speed.
Tone 0~10 Adjusts tonal quality.
Level 2~100 Adjusts signal level after passing module.
Threshold 0~50 Adjusts threshold for compressor/limiter action.
Ratio 1~10 Adjusts compressor/limiter compression ratio.
Release 1~10
Adjusts delay until compressor/limiter release from point where signal
level falls below threshold level.
Parameter descriptions
Type Parameters/Descriptions
Auto Wah
Position Sense Resonance Level
Auto wah dependent on dynamics of input signal.
Tremolo
Depth Rate Wave Level
Periodically varies the volume level.
Phaser
Position Rate Color Level
Produces a swooshing sound.
Ring
Modulator
Position Frequency Balance Level
Produces a metallic ringing sound. Adjusting the Frequency parameter results in a drastic change of sound character.
Slow Attack
Position Time Curve Level
Slows down the attack rate of the sound.
Fix-Wah
Position Frequency Dry Mix Level RTM Mode RTM Wave RTM Sync
Changes the wah frequency according to rhythm tempo.
Parameter descriptions
Parameter
name
Setting range Description
Position Before, After Sets connection position of EFX module to “before” or “after” preamp.
Sense −10~−1, 1~10 Adjusts auto wah sensitivity.
Resonance 0~10 Adjusts resonance intensity.
Level 2~100 Adjusts signal level after passing module.
Depth 0~100 Adjusts modulation depth.
Rate 0~50 (P86 Table1) Adjusts modulation rate. Can be set in rhythm tempo note units.
Wave Up 0~9, Down 0~9, Tri 0~9
Sets modulation waveform to “Up” (rising sawtooth), “Down” (falling
sawtooth), or “Tri” (triangular). Higher values result in stronger clipping,
emphasizing the effect.
Color 4Stage, 8State, Invert4, Invert8 Selects sound type.
Frequency
Ring Modulator: 1~50 Adjusts frequency used for modulation.
Fix-Wah: 1~50 Adjusts wah center frequency.
Balance 0~100 Adjusts balance between original sound and effect sound.
Time 1~50 Adjusts rise time for sound.
Curve 0~10 Adjusts volume rise curve.
Dry Mix 0~10 Adjusts original sound mix ratio.
RTM Mode P86 Table 2 Adjusts change range and direction.
RTM Wave P86 Table 3 Selects control waveform.
RTM Sync (P86 Table 4) Adjusts control frequency.
EFX module