Zoom R16 - Manual (Page 36)

35
16-track synchronized recording by connecting two R16s
If you want to record more then 8 tracks at the same time for a band performance, for example, you can
increase the number of tracks by connecting two R16s with a USB cable.
1
Press [TOOL].
1
Press [TOOL].
Command keys that effect both sender and receiver.
P R O J E C T
> S Y S T E M
Change
menus
Select
2
Press [ENTER].
P R O J E C T
> S Y S T E M
Change
menus
Select
2
Press [ENTER].
S Y S T E M
> S Y N C R E C
Change
menus
Select
3
Press [ENTER].
S Y S T E M
> S Y N C R E C
Change
menus
Select
3
Press [ENTER].
Make sender settings.
Set the R16 that will be used for key control as the Master.
Make receiver settings.
Set the R16 that receives commands as the Slave.
Master/Slave
Select
4
S Y N C R E C
> M a s t e r
Press [ENTER].
USB Indicator: [HOST] light on
Master/Slave Press [ENTER].
Select.
4
S Y N C R E C
> S l a v e
USB Indicator: [DEVICE] light on.
5
Connect two R16 with a USB cable.
Tool
NOTE
• Perfect synchronization of the start timing in
recording by two R16s is not guaranteed.
• There will be a gap of approximately 1-2 ms.
[REC] key [FF] key
[PLAY] key [REW] key
[STOP] key
Plug a USB 2.0 (AB-type) cable into the
socket that has a lit indicator.
HINT
Tool>System>Sync rec
>SYSTEM
.
>SYNC REC
>Master
.
>SYSTEM
>SYNC REC
>Slave
.
.
. .