Zoom R16 - Manual (Page 32)

Using the counter and marker
s to mo
ve (locate)
Place a mark using the counter
Place a mark during recording/playback
31
Using the counter and markers to move (locate)
The counter indicates recording time and elapsed time in minute/second/millisecond and bar/beat/tick
(1/48beat). Use it to set marks that you can then quickly move (locate) to in your project.
Place a mark Locate a time or position using
the counter
Preparation: Stop the recorder.
Select the project.
Start from the top screen.
HINT
• After Step 3 you can start playback from the set
counter value.
NOTE
• You cannot use these procedures during recording/
playback.
In the middle of recording/playback
1
Select hour: minute: second or
bar-beat-tick.
Hour: minute: second: millisecond
Switch
P R J 0 1 P R J 0 0 1
0 0 0 0 : 0 0 : 0 0 : 0 0 0
Bar- beat- tick (1/48 beat)
Switch
P R J 0 1 P R J 0 0 1
0 0 0 0 - 0 0 - 0 0 0
3
Change the values.
Move between
items
P R J 0 1 P R J 0 0 1
0 0 0 0 : 1 5 : 0 0 : 0 0 0
HINT
Mark icon display
Counter is at the indicated mark
No mark registered at this counter position
Mark Numbers
Mark 0 = Counter 0. This is the head of the
project. You cannot change this particular mark.
• If you place a new mark ahead of a registered
mark, all the following marks will be automatically
renumbered in order.
• You can place a maximum of 100 marks in one
project.
ト 0 3 0 0 0 : 1 0 : 0 8 : 0 1 5
Mark number 3 is located at 10 minutes, 8 seconds, 15
milliseconds.
P R J 0 1 P R J 0 0 1
0 1 0 0 : 0 1 : 1 2 : 0 3 7
Marker icon
Mark number
1
Press [MARK/CLEAR].
Start from the top screen.
Set the counter to the
desired mark position.
Move between
items
P R J 0 1 P R J 0 0 1
0 0 0 0 : 0 1 : 1 2 : 0 3 7
P R J 0 1 P R J 0 0 1
0 0 0 0 : 0 6 : 1 9 : 0 0 4
P R J 0 1 P R J 0 0 1
0 1 0 0 : 0 6 : 1 9 : 0 0 4
1
Press [MARK/CLEAR].
2
P R J 0 1 P R J 0 0 1
0 0 0 0 : 0 0 : 0 0 : 0 0 0
Move between units, the
selected item blinks
Choose the desired unit.
(Hour: minute: second: millisecond
or bar-beat-tick.)