Off alarm on, Dgps gps type gps – TeeJet CenterLine User Guide v2.02 User Manual
Page 18
14 Chapter 2 - Setup
Figure 2-19: Alarm Selection
Table 2-5: Alarm Settings
GPS Type
GPS Type indicates to the CenterLine system if the GPS receiver is differentially corrected. To adjust
the GPS Type, navigate to
and press the Enter button. Options include
press the Enter button to save the settings and return to the Guidance setup menu.
Figure 2-20: GPS Type Selection
Table 2-6: GPS Type Settings
1 Hz MSG
A 1 Hz data rate is not recommended for vehicle guidance, so a “GPS SLOW” message will be dis-
played on the lightbar to notify the operator if the GPS receiver is set to a 1 Hz data rate. However,
there are some areas where the 1 Hz rate is used. For those areas, the ability to disable the “GPS
SLOW” message has been established.
To enable or disable the “GPS SLOW” message, navigate to
until <1 HZ MSG> is displayed and press the Enter button. Options are
the appropriate option using the Arrow buttons and press the Enter button to save the settings and
return to the Guidance setup menu.
Setting
Description
Off
No applied area detection.
On
Applied area detection. Alarm will sound.
Setting
Description
GPS
GPS receiver with no differential correction, capable of providing positioning accuracy of
approximately 10 meters.
DGPS
GPS receiver with differential correction, capable of providing sub-meter positioning accuracy.
Off
Alarm
On
DGPS
GPS Type
GPS
Arrow buttons
Enter button