beautypg.com

8 height, Off status on – TeeJet CenterLine User Guide v2.02 User Manual

Page 17

background image

CenterLine 2.02

98-05054 R6

13

Antenna - Height

The Height setting defines the height of the GPS antenna to the ground surface. This value is used
only when a tilt sensor is connected. To change the height setting, navigate to , use
the Arrow buttons until is displayed, and press the Enter button. Use the
Arrow buttons to select and press the Enter button. Using the Arrow buttons, enter the
height value until the desired distance is displayed in the text window. Press the Enter button to save
the setting and return to the Guidance setup menu.

Figure 2-17: Establishing Antenna Height

Status

If a Swath Manager 5 is connected to the system, the Status option will be removed from the main
setup. Status setup is used to auto detect implement status. When the status detect is properly
implemented, CenterLine will detect whether product delivery is ON or OFF based on the vehicle
product ON/OFF switch. Refer to Figures 2-1 and 2-2 for the location of status connect (boom
sense) wiring.

To adjust Status, navigate to , use the Arrow buttons until is displayed and
press the Enter button. Options are either ON or OFF. Use the Arrow buttons to choose the appropri-
ate option and press the Enter button to save the settings and return to the Guidance setup menu.

Figure 2-18: Status Selection

Table 2-4: Status Settings

Alarm

The Alarm setting, when enabled, notifies the operator when entering a previously applied area. The
text window will display when the implement swath enters a previously applied area of a
field. To adjust the alarm setting, navigate to , use the Arrow buttons until
is displayed and press the Enter button. Options are either ON or OFF. Use the Arrow buttons to
choose the appropriate option and press the Enter button to save the settings and return to the Guid-
ance setup menu.

Setting

Description

Off

No status detect is implemented. This is the default setting.

On

Status detect assumes a single swath centered on the vehicle.

9.8

Height

Off

Status

On

NOTE:

When

is set to ON, +12V
must be supplied
to the boom sense
wire when booms
are ON. If this
does not occur,
applied area
detection will not
work. Refer to the
CenterLine wiring
tips document 98-
01095.

Arrow buttons

Enter button