ClearOne comm PSR1212 - Manual (Page 138)

132
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Glossary
Mixer mode The mixer mode has two settings: master and slave. Mixer mode can
be configured from the front panel or in the Unit Properties window.
Mute A condition in which an audio signal is attenuated below the audible
threshold.
Number of Open Mics (NOM)/Constant Gain Mode Adjusts the output level
based on the number of mics gated on and routed to an output.
O–R buses These four audio buses communicate NOM count and mic mixing
parameters.
Off Attenuation The amount of level reduction a microphone is given when the
microphone is not gated on.
PA Adaptive Mode The PSR1212 recognizes how much loudspeaker audio is
picked up by the microphones and then uses this level as the new ambient level when
audio is present at the power amplifier. This prevents loudspeaker audio from gating
on a microphone, while still allowing people in the room to gate on microphones as
they speak.
PA Adapt Reference This G-Ware setting determines which output (typically for a
loudspeaker) is used as a reference for an input.
PA Adapt Reference bus This bus carries reference information, making it
possible for an input to reference an output on another linked unit.
Parametric Equalizer (PEQ) A multi-band variable equalizer with control of gain,
center frequency, and bandwidth. A properly configured PEQ enables the PSR1212
to offset loudspeaker or room acoustic deficiencies.
Passwords The PSR1212 features several passwords to protect system
configuration.
• Front panel The front panel password prevents a user from changing settings
in the front panel LCD menus. The password can be set from the front panel or
through G-Ware.
• Macro The macro password is created in the Unit Properties window and
makes it possible to lock certain macros. A locked macro can be run without
the password. However, a password must be entered to edit the macro.
• Modem The modem password can be created serially using the MPASS
command or through G-Ware in the Unit Properties window. The password is
required to allow remote modem access.