Compaq AA-RHGWC-TE - Manual (Page 287)

• DLT3 Bus ID: 4
• DLT4 Bus ID: 5
• DLT5 Bus ID: 6
7. Press Enter when you have the item selected for which you wish to
change the SCSI ID.
8. Use the up and down arrows to select the desired SCSI ID. Press the
Enter button to save the new selection.
9. Press the Escape button once to return to the Set SCSI Submenu to
select another tape drive or the library robotics, and then repeat steps 6,
7, and 8 to set the SCSI ID.
10. If there are other items you wish to configure, press the Escape button
until the Configure submenu is displayed, then select the item to be
configured. Repeat this procedure for each item you wish to configure.
11. If there are no more items to be configured, press the Escape button
until the Default window is displayed.
______________________ Note _______________________
You do not have to cycle power to set the SCSI IDs.
8.13 Compaq ESL9326D Enterprise Library
The topics in this section provide an overview and hardware configuration
information on preparing the ESL9326D Enterprise Library for use on a
shared SCSI bus with the TruCluster Server.
8.13.1 General Overview
The Compaq StorageWorks ESL9326D Enterprise Library is the first
building block of the Compaq ESL 9000 series tape library.
For more information on the ESL9326D Enterprise Library, see the following
Compaq StorageWorks ESL9000 Series Tape Library documentation:
• Unpacking and Installation Guide
• Reference Guide
• Maintenance and Service Guide
• Tape Drive Upgrade Guide
Configuring a Shared SCSI Bus for Tape Drive Use 8–73