Compaq AA-RHGWC-TE - Manual (Page 234)

Table 8–6: Hardware Components Used to Create the Configuration Shown
in Figure 8–6 (cont.)
Callout Number Description
8 H885-AA trilink connector
9 BN21M cable
10 H8574-A terminator
a The maximum length of the BN38C (or BN38D) cable on one SCSI bus segment must not exceed 25 meters.
b The maximum length of the BN37A cable must not exceed 25 meters.
c The maximum combined length of these cables must not exceed 25 meters.
8.6 Preparing the TZ887 for Shared SCSI Bus Usage
The TZ887 Digital Linear Tape (DLT) MiniLibrary combines a cartridge tape
drive (TZ88) and an automatic cartridge loader. It uses a seven-cartridge
(CompacTape IV) removable magazine with a total capacity of nearly 280
GB compressed. It is capable of reading/writing at approximately 10.8 GB
per hour.
As with any of the shared SCSI devices, the TZ887 SCSI IDs must be set
to ensure that no two SCSI devices on the shared SCSI bus have the same
SCSI ID.
The following sections describe how to prepare the TZ887 in more detail.
8.6.1 Setting the TZ887 SCSI ID
The TZ887 SCSI ID is set with a push-button counter switch on the rear of
the unit (see Figure 8–8). Push the button above the counter to increment
the address; push the button below the counter to decrement the address
until you have the desired SCSI ID selected.
8–20 Configuring a Shared SCSI Bus for Tape Drive Use