Compaq AA-RHGWC-TE - Manual (Page 213)

___________________ Caution ___________________
Do not abort the update — doing so can cause a corrupt flash
image in a firmware module.
A complete firmware update takes a long time. The length of
time increases proportionally to the number of PCI adapters
you have.
9. After you update the firmware, use the verify command to verify
the firmware update, then transfer control back to the SCM and reset
the system:
P00>>> Esc Esc scm
SCM_E0> reset
10. Set the hard partitions back to the original configuration:
SCM_E0> set hp_count 2
11. At the master SCM, turn system power on:
SCM_E0> power on
12. At the master SCM, transfer control to the SRM. Then, using the SRM
at the console of each partition, boot the operating system.
Using GS80, GS160, or GS320 Hard Partitions in a TruCluster Server Configuration 7–21