Compaq AA-RHGWC-TE - Manual (Page 149)

______________________ Notes ______________________
Use Ctrl/H to correct typing errors.
Use the logout command to log out from any telnet connection.
6.5.1.2.5 Setting the Switch Name via Telnet Session
After you set the IP address and subnet mask, you can use a telnet session
to log in to the switch to complete other switch management functions or
monitor switch status. For example, if a system’s /etc/hosts file contains
an alias for the switch’s IP address, set the switch name to the alias. This
allows you to telnet to the switch name from that system. Telnet from a
system that has the IP address in its /etc/hosts file and set the switch
address as follows:
# telnet 132.25.47.146 Return
User admin Return
Passwd Return
:Admin> switchName fcsw1 Return
:Admin> switchName Return
fcsw1
:Admin>
______________________ Note _______________________
When you telnet to the switch the next time, the prompt will
include the switch name, for example:
fcsw1:Admin>
6.5.2 Installing and Configuring the KGPSA PCI-to-Fibre Channel
Adapter Module
The following sections discuss KGPSA installation and configuration.
6.5.2.1 Installing the KGPSA PCI-to-Fibre Channel Adapter Module
To install the KGPSA-BC or KGPSA-CA PCI-to-Fibre Channel adapter
modules follow these steps. For more information, see the following
documentation:
• KGPSA-BC PCI-to-Optical Fibre Channel Host Adapter User Guide
Using Fibre Channel Storage 6–23