Compaq AA-RHGWC-TE - Manual (Page 148)

When you have completed setting the IP address and subnet mask,
disconnect the PC or terminal from the DS-DSGGB-AA or DS-DSGGC-AA
switch.
6.5.1.2.4 Logging In to the Switch with a Telnet Connection
Before you telnet to a Fibre Channel switch, you must set the Ethernet IP
address and subnet mask.
______________________ Note _______________________
A serial port connection and a telnet session cannot both be active
(at the same time) with the DS-DSGGB-AA and DS-DSGGC-AA
switch. The telnet session takes precedence and the serial port
session is aborted when the telnet session is started.
You can use a telnet session to log in to the switch at one of three security
levels. The default user names, shown from lowest security level to highest
security level, are shown in Table 6–1.
Table 6–1: Telnet Session Default User Names for Fibre Channel Switches
DSGGA DSGGB or
DSGGC Description
other n/a Allows you to execute commands ending in
Show
, such as dateShow and portShow.
user user Allows you to execute all commands ending in
Show
, plus any commands from the help menu
that do not change the state of the switch, for
example, version and errDump. You can
change the passwords for all users up to and
including the current user’s security level.
admin admin Provides access to all the commands that show
up in the help menu. Most switch administration
is done when logged in as admin.
n/a root Gives users access to an extensive command set
that can significantly alter system performance.
Root commands should only be used at the
request of Compaq customer service.
You can set the user names and passwords for users at or below the security
level of the present login level by executing the passwd command. Enter a
new user name (if desired) and a new password for the user.
6–22 Using Fibre Channel Storage