Brother WP-700D - Manual (Page 97)

NOTES:
• Margins cannot be set while in display mode (centering, right margin flush,
decimal tab) or in UL mode.
• There must be at least two inches between margins.
• The margin settings are reset to their default values when you switch the
power off, then on.
Selecting the Pitch
^
CODE
-----------
^ in
1
Pressing [CODE] + [PITCHI changes the pitch through the following cycle:
PITCH:10 ^ 12 ^ 15 ^ 10
Pitch Number of Characters per inch
10 (PICA) 10 characters per inch
12 (ELITE) 12 characters per inch
15 (MICRON) 15 characters per inch
NOTES:
The pitch cannot be changed while in display mode (centering, right margin
flush, decimal tab mode).
The pitch can be changed in UL mode only before entering text on the
screen.
The pitch setting is reset to its default value when you switch the power off,
then on.
Selecting the Line Space
^ CODE
il-------------
Vb
2
LINE
Pressing ICODEI + changes the line space through the following cycle:
L.SP:1.0 ^ 1.5 ^ 2.0 ^ 1.0
Line Spacing Number of Lines per inch
1.0 6 lines per inch
1.5 4 lines per inch
2.0 3 lines per inch
NOTE:
The line space setting is reset to its default value when you switch the power
off, then on.
89