ALTANA Wave-Scan II - Manual (Page 30)

29
English
A confirmation display appears which
allows to verify that the entered data is
correct.
Next, a selection menu may appear to
enter an additional parameter.
Proceed as described above.
If a memory is selected that already
contains measurements, the test series
can be continued.
A display appears to confirm this. By
selecting No, a new test series will be
started.
The device goes to the measurement
mode, you can start taking readings.
Once you have reached the preset
number of measurements (n = ...),
you might be prompted to enter a
name for the checkzone (“Input
Checkzone” aktivated).
Proceed by entering the name of the
checkzone as described above for the
parameters.
If “Input Checkzone” is deactivated,
the instrument automatically assigns
the name SAMPLE 01 and then
increments this name.
To exit the test series, presss the scroll
wheel and activate End Test Series.
Measure 9