ALTANA Micro-Gloss Short Instructions - Manual

269 020 584 E 0806
Additives & Instruments
A member of
Measure what you see.
BYK-Gardner GmbH · Lausitzer Strasse 8 · 82538 Geretsried · Germany · Tel. +49-8171-3493-0 · Fax +49-8171-3493-140 · www.byk.com/instruments
Please note the detailed operating instructions in English on CD.
ENGLISH
micro-gloss Operation
mode wheel:
• Switch on press
• Show menu press
• Select function scroll
• Activate function press
operate-button:
• Measure
operate
How to calibrate?
Gloss
• Turn on the unit in holder
• Autodiagnosis checks standard
and calibration
• If requested, clean the standard
and start calibration by pressing
the mode wheel
*It is advisable, to perform the zero calibration on the uncoated
metal of the sample to be tested.
Main menu
Mode }
Geometry/Sensor }
Memory }
Difference }
Calibration }
Setup *}
¢
Navigation Symbols:
Back to previous menu
} Got to sub-menu
3
Function activated
* Guide to language menu
¢
Thickness (only micro-TRI-gloss μ)
Autodiagnosis
Please clean standard
Confirm ¢ [mode]
Cancel ¢ [operate]
Main menu
Calibration }
Calibrate }
Thickness Fe }
Thickness NFe }
• Select the desired sensor
(Fe or NFe)
• Put the unit on the zero
standard or original substrate*
• Press operate button
• Hold the unit free in air and
press operate