AERCO AM Series Boiler User Manual - Manual (Page 28)

AM Series Boilers and Water Heaters
CHAPTER 3 – INSTALLATION
Page 28 of 156 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 OMM-0100_0B
PRI - 07/14/14
Ph.: 800-526-0288
GF-146
3.2 Boiler and Water Heater Installation Location Factors
When locating the boiler or water heater, the following factors must be considered:
Boilers
• location of vent/air intakes;
• connection to the gas supply;
• connection to the water supply;
• connection to the heating system;
• connection to the electrical supply;
• disposal of the condensation produced by the boiler;
• connection to the room thermostat, building automation system, or equivalent device;
• piping of the safety relief valve discharge;
• connection of the outdoor temperature sensor;
• possible connection of an indirect water heater;
•
If flooding is possible, elevate the boiler sufficiently to prevent water from reaching the unit;
Heater Factors
• The location of vent/air intakes;
• connection to the gas supply;
• connection to the water supply;
• connection to the electrical supply;
• disposal of the condensation produced by the boiler;
• piping of the safety relief valve discharge;
• connection of a storage tank;
•
If flooding is possible, elevate the boiler sufficiently to prevent water from reaching the unit;