AERCO AM Series Boiler User Manual - Manual (Page 152)

AM Series Boilers and Water Heaters
APPENDIX B – FACTORY MENU
Page 152 of 156 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 OMM-0100_0B
PRI - 07/14/14
Ph.: 800-526-0288
GF-146
APPENDIX B: FACTORY MENU
Inappropriate changes to parameters in the Factory Menu (See Tables B-1 and B-2) could result
in a unit or system malfunction. For th
is reason, only a qualified technician who has in-depth
knowledge of the unit should make any changes to the parameters in this menu. The
parameters available allow the unit to be configured and set for proper operation.
The Factory Menu for boilers and water heaters are different from one another, so each is
illustrated separately in Figures B-1 and B-2.
To enter the Factory Menu, perform the following steps:
Factory Menu Navigation and Adjustment
1. Turn the electrical power switch to OFF.
2. Simultaneously press and hold the RESET and buttons.
3. While the RESET and buttons are both depressed, turn the power switch to ON.
4. Wait until the word “init” is displayed in the control panel display, or until the control
panel display begins to show the 3000 parameters, then release the RESET button and
then the button.
5. Press the and buttons to scroll up or down through the parameters.
6. To change a displayed parameter, press the RESET button. The parameter value will
blink.
7. Press the and buttons to cycle up or down through the parameter
values.
8. To set a parameter value, press the RESET button while the desired value is displayed.
9. Wait at least 10 seconds after the last parameter change before exiting menu.
10. Exit the menu by turning the unit power switch to OFF.
11. The power switch may now be turned ON, and the Factory Menu will no longer be
displayed.