KEYENCE LK-H1W User Manual
Page 66
3-38
LK-H1W-M-NO3-E
3 Operations and Functions of Software
3
■
Basic data storage procedure
1
Click [Data Storage Setting].
The Target OUT, the Number of storages and the Storage cycle should be set
beforehand.
2
Click the [Start Storage] button.
The controller starts storing the measurement data.
When the number of data reaches the set number that is specified by [Number of
storages], the storage stops automatically.
• If you want to stop the data storage in the middle of storage, click the [Stop Storage]
button.
• When you click the [Start Storage] button again after the storage is stopped once, the
storage is resumed from the point where the storage was stopped.
3
Click the [Read Storage Data] button.
The [Read Storage Data] window appears.
4
Click the [Readout] button.
The data that are accumulated in the controller are transferred to the PC.
When the bar graph indicating the transfer status reaches the right-most end,
reception of the data is complete.
For the procedure of [Data Storage Setting], refer to "Data Storage Setting" (page 3-39).
For the method to set [Read Storage Data], refer to "Read Storage Data" (page 3-41).
2
1
3
Reference
4