KEYENCE LK-H1W - Manual (Page 63)

3-35 LK-H1W-M-NO3-E
3 Operations and Functions of Software
3
A maximum of the following four data can be displayed as the waveforms on the [Data
Storage] window. The data listed below can be displayed.
• The storage data that is read out from the main unit.
• The storage data that has been stored in a PC.
Size of the [Data Storage] window can be changed.
Size of the [Data Storage] window cannot be reduced smaller than the original size of the
window.
1. Data Storage Setting
Set the method to store the measured data.
2. Storage Data Readout
Reads out the storage data from the controller.
3. Start Storage
The controller starts storing the data.
4. Stop Storage
The controller stops storing the data.
5. Clear Stored Data
The data that is stored in the controller is cleared.
Clear Stored Data clears all data that is stored in the controller.
6. Status Display
The data storage status of the controller is displayed.
The statuses listed below can be displayed.
Refer to "Data Storage Setting" (page 3-34).
Refer to "Read Storage Data" (page 3-41).
Status Status on display Number of storage data display
Not connected Not connected *****
NORMAL mode: Storage in progress Storage in progress Number of data that are being
stored at present
NORMAL mode: Stopping in progress Stopping in progress Number of data that are being
stored at present
When communication error occurs ***** *****
When another system error occurs System error *****
Reference
Note
Reference