KEYENCE LK-H1W - Manual (Page 44)

3-16 LK-H1W-M-NO3-E
3 Operations and Functions of Software
3
4
Place the Master Work-piece below sensor for measurement, and click the [Set]
button of [Input 2].
The measured value obtained from the Master Work-piece is entered in [Input 2].
5
Set the Scaling on [Output 1] and [Output 2].
6
Click the [OK] button.
■
The procedure to copy the OUT’s setting to the other OUT’s setting
Copying the OUT1 setting to OUT2 is described as an example.
Complete all settings of [OUT1].
1
Click the [Copy the OUT1 settings] button.
The [Paste OUT settings] button becomes active.
2
Select the [OUT2] tab.
You can copy the OUT’s setting to the OUT of any other program No. To paste the OUT’s
setting to that of other Program No., select first the desired Program No., then select the
desired OUT.
3
Click the [Paste OUT settings] button.
1
2
Reference
3