Hardy HI 6500 Series User Manual
Weight processor hi 6500 series
Table of contents
Document Outline
- Weight Processor
- HI 6500 Series
- User’s Guide
- Contents
- HI 6500 Overview
- Specifications
- HI 6500 Installation
- Unpacking
- Spare Parts List
- Tool List
- Installing the HI 6500 Series Instrument
- Chapter 4
- Network Configuration
- Ethernet TCP/IP Network Configuration
- LAN Connection
- Ethernet-UDP
- I/O Tables For Communications to PLCs
- EtherNet/IP™
- Modbus TCP
- Modbus-RTU (over RS-485)
- Profibus-DP
- Printer (over RS-232)
- USB Memory Stick
- Communications Parameters for the HI 6510 Only
- Chapter 5
- Instrument Configuration
- Using the Home Page to set Parameters
- Using the Front Panel Display Menus to Set Parameters
- Front Panel Display
- The Five Button Command Cluster
- Using the Mode, Zero, and Tare buttons
- Commands and Parameters
- Calibration Menu
- Hard Cal Commands and Parameters
- Communication Menu
- Modbus TCP Commands and Parameters
- Modbus-RTU Commands and Parameters
- Profibus-DP Commands and Parameters
- Printer Command Parameters
- USB Memory Stick Parameters
- 4-20 mA Communications Commands and Parameters
- Diagnostics Parameter Menu
- Display Parameter Menu
- Operations Parameter Menu
- Security Parameter Menu
- Setup Parameter Menu
- Default Parameter IDs and Values
- Chapter 6
- Calibration
- Operation
- Security
- Chapter 9 Troubleshooting
- Disassembly and Reassembly Notes, Warnings & Cautions
- Error Messages
- Trouble Shooting Using Integrated Technician (IT®)
- Weight and Voltage ALL
- General Troubleshooting Flow Chart Index
- A - Guideline Instability: Electrical and Mechanical review.
- A1. Checking for Unstable Components in a Weighing System
- B. Guidelines for Electrical, Mechanical or Configuration Issues
- B1 - Guidelines to Verify Electrical Installation
- B2 - Guidelines to Verify Mechanical Installation
- B3 - Guidelines to Verify Configuration/Filter Settings to Improve Stability
- C - Integrated Technician and Stability Test Overview
- E Testing for Non-Return to Zero (System with IT Summing Card.)
- F. Verify Individual Load Sensor Millivolt Output readings
- G- Calibration Errors When Performing the Calibration
- H. Mechanical Installation
- J- Electrical Inspection
- K - Installation Check Points
- M. Weight Processor’s Front Display is Blank or Locked
- N. Analog Out (HI 6510 Only)
- Tests and Diagnostics
- System and Load Cell Tests
- HI 6500 Series USER GUIDE Index