Panel mount option 1 – Hardy HI 6500 Series User Manual

Page 21

Installation

•

Panel Mount Option 1

FIG. 1 Exploded View of the Panel Mount Assembly – Option 1 with optional

mounting kit

Step 1. Screw the Panel Mounting Brackets to the top of the enclosure

Step 2. Connect and hand tighten the four screw rods into the front panel display

Step 3. Push the screw rods and cable assembly though the holes in the panel.

Step 4. Connect the front panel display cable assembly

Step 5. Tighten the four 4mm nuts enough to completely compress the gasket for IP65

Step 6. Position the enclosure with the connectors at the back

Step 7. Align the screw rods with the holes in the brackets and the enclosure

Step 8. Connect the cable assembly

Step 9. Slide the enclosure onto the screw rods until flush with the panel

Step 10. Install and tighten keeper nuts.

CAUTION:

Do not over tighten the bracket screws or the mounting nuts as this may damage the
enclosure.

ATTENTION

Ne pas trop serrer les écrous de montage car cela pourrait endommager l'enceinte.

