Dillon FI-127 - Manual (Page 56)

56
6. Press +/- . . . ForcE is displayed and the ACCEPT
annunciator illuminates indicating that
you are selecting items.
7. Scroll through the list of available
layout items by pressing the
MENU key until LFS is
displayed. . . LFS is displayed.
8. Press ENTER. . . 0 is displayed.
9. Key in the number of line feeds
you want, 1 for this example, and
press ENTER. . . 1 LF is displayed.
10. Press ESCAPE to return to. . . LAY. 01
The Groups submenu is where you specify which ports will print which layouts.
A total of nine groups is available. There are six that are predefined. Within each
group, up to three ports can output layouts. Port one is standard; ports 2 & 3
are offered only if additional serial boards are installed. Each port is then
assigned a layout to print. Here are two examples of how the groups might be set
up:
Group 1: Port 1 prints Layout 1 Group 2: Port 1 prints Layout 5
Port 2 prints Layout 2 Port 2 prints nothing
Port 3 prints Layout 3 Port 3 prints Layout 2
The default group settings are:
Group # Port 1 Port 2 Port 3
1 Layout 5 None None
2 Layout 6 None None
3 Layout 7 None None
4 Layout 8 None None
5 Layout 10 None None
6 Layout 14 None None
Follow the instructions below to set up your groups.
1. With GrouPS displayed,
press ENTER. . . GrouP 1 is displayed.
2. Press MENU to scroll through
the list of available groups.
To insert a new group, with End
displayed, press +/-. A total of nine
groups is available. When the
group you wish to define is
displayed, press ENTER. . . Port 1 is displayed.
Groups
The default for the PRINT key is
Group 2.
You may print other groups by
keying in the correct group number,
then pressing PRINT. Note: This
option must be enabled in the
service menu first.