Dillon FI-127 - Manual (Page 13)

13
3. Press the ENTER key to start or
stop capturing data points. . . The indicator will start or stop captur-
ing data points.
4. Press the MENU key to move to
the next menu item. . . rEPOrt is displayed. Use this to print a
report on the data capture information.
5. Press the ENTER key with this
displayed if you want a
preconfigured set of information
to be sent through the serial port.
6. Press the MENU key to move to
the next menu item. . . Point is displayed. Use this to see any
captured data point.
7. Press the ENTER key to view the
current point number. Press Е Е Е Е Е or
MENU to scroll to other points.
With the point you want displayed,
press the ENTER key to see the
value of that data point. . . The captured point will be displayed as
well as the unit of measure and tension/
compression annunciators.
8. Press the MENU key to move to
the next menu item. . . StAtS. is displayed. Under this item you
can see statistics on the captured data
points.
9. Press ENTER to see the first item
in the list of statistics. Press the Е Е Е Е Е
or MENU to move to other stat.
items and press ENTER to see the
value for the displayed statistic.
Following are the statistics and
what they show you:
Top Peak value for the currently captured points.
First Shows the first peak value for the currently captured points.
Average Shows the mean value of the currently captured points. Does
not include those points which are below the data capture
threshold set in the Ave. Over parameter of the setup menu.
See the Service Manual.
Hour Time at which the data was captured.
Day Date on which the data was captured.
Remember to use the direction keys
to navigate among the levels and
choices in the menu structure.
Press SELECT to accept the
current selection and return to the
Display mode from anywhere in the
menus.