Dillon FI-127 - Manual (Page 12)

12
The FI-127 has two menus—the user menu and the service menu. The service
menu is covered later in this manual. You use it to configure the operation of your
indicator. The user menu, shown in Figure 3, allows you to do the following things:
• Capture and view data points
• Print a report on data points
• View statistics about captured data points
• Delete captured data points
• View the current time and date
• View and delete database records
• See live display of loadcell output in counts or mV/V
• Set Target, Under, and Over values
Following are instructions for accessing and using the user menu. Refer to Figure 3
as you go through these instructions.
1. Press the MENU key. . . CAPturE is displayed. This is the first
menu item. Use this to start and stop
capturing data points, view captured
points, see statistics on captured points
and to delete the points.
2. Press the ENTER key. . . StArt or StoP is displayed depending
on if you are currently capturing data
points or not.
Using the User Menu
Figure 3
User menu
This manual assumes that all
functions are enabled. Your indicator
may not show some of the items in
the user menu because your
configuration does not enable them.
See the Using the Service Menu
section to reconfigure your system.
The User Menu
Capture
Use these keys to navigate
through the menus:
ESCAPE = up
ENTER = down
Е Е Е Е Е = left
MENU = right