Dillon FI-127 - Manual (Page 40)

40
Freeze - Causes the Force display to be frozen. See the
section Freeze Force Function.
Unfreeze- Causes a frozen force to be unfrozen. See the
section Freeze Force Function
Capture - Starts the data capture process.
Database - Use this item to enable or disable database report output
and specify which group to use. Choose a group number
under Report to enable the function and choose No to
disable it.
Under Record, you define the database record format.
Any of the following items can be included in any order
but only once. If one of the force measurement items is
included, the unit of measure, identification (force, peak,
1st peak), and tension/compression are also saved for that
record within the database.
Force - Force measurement
Top - Peak value
First - 1st peak
Display - Force, Frozen force, Peak or 1st Peak, depend-
ing on display mode.
Selected - Force, Peak or 1st Peak, depending on display
mode.
Loadcell - Currently selected loadcell number.
Id - Id value.
Hour - Current time.
Day - Current date.
End - End of the list. Insertions and deletions may be
performed with the +/- and ZERO keys
anywhere within this list.
Capture - This is the last item in the Define submenu. Use this item
to configure data capture.
Under Report, enable the data capture function by
choosing which group to use. Disable it by choosing No.
Under Interval, set the time, in seconds, between
captured points. If you set a value of 0, the data capture
function is disabled.
Under Points, set the number of data points to be
captured. Can be 0-4000. Entering 0 disables data capture.
Default value is 3600 which is equal to one minute of data
if capture rate is 60 Hz.
Under Ave. Over, set the data capture threshold for
computing the average. The value is expressed as a
percent of full capacity referenced from the current zero
balance. 10% is the default setting. Can be as high as 100%.
See detailed notes on data capture
in the section Data Capture later in
this manual