Kontron AT8901M CLI - Manual (Page 83)

AT8901M Switching Commands
Page 2 - 47 AT8901M CLI Reference Manual
ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.
Default 5
Format
storm-control broadcast level <0-100>
Mode Interface Config
2.11.2.1 no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for an
interface and disables broadcast storm recovery.
Format
no storm-control broadcast level
Mode Interface Config
2.11.3 storm-control broadcast all
This command enables broadcast storm recovery mode for all interfaces. If the mode is
enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of broadcast traffic will be limited to the configured
threshold.
Default disabled
Format
storm-control broadcast all
Mode Global Config
2.11.3.1 no storm-control broadcast all
This command disables broadcast storm recovery mode for all interfaces.
Format
no storm-control broadcast all
Mode Global Config
2.11.4 storm-control broadcast all level
This command configures the broadcast storm recovery threshold for all interfaces. If
the mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of broadcast traffic will be limited to the
configured threshold.This command also enables broadcast storm recovery mode for
all interfaces.
Default 5
Format
storm-control broadcast all level
<0-100>
Mode Global Config
2.11.4.1 no storm-control broadcast all level
This command sets the broadcast storm recovery threshold to the default value for all
interfaces and disables broadcast storm recovery.