Kontron AT8901M CLI - Manual (Page 146)

Routing Commands AT8901M
AT8901M CLI Reference Manual Page 3 - 32
Mode Router OSPF Config
3.7.24 distribute-list out (OSPF)
Use this command to specify the access list to filter routes received from the source
protocol.
Format
distribute-list
<1-199>
out
{rip | static | connected}
Mode Router OSPF Config
3.7.24.1 no distribute-list out
Use this command to specify the access list to filter routes received from the source
protocol.
Format
no distribute-list
<1-199>
out
{rip | static | connected}
Mode Router OSPF Config
3.7.25 exit-overflow-interval (OSPF)
This command configures the exit overflow interval for OSPF. It describes the number
of seconds after entering Overflow state that a router will wait before attempting to
leave the Overflow State. This allows the router to again originate non-default AS-
external-LSAs. When set to 0, the router will not leave Overflow State until restarted.
The range for seconds is 0 to 2147483647 seconds.
Default
0
Format
exit-overflow-interval
Mode Router OSPF Config
3.7.25.1 no exit-overflow-interval
This command configures the default exit overflow interval for OSPF.
Format
no exit-overflow-interval
Mode Router OSPF Config
3.7.26 external-lsdb-limit (OSPF)
This command configures the external LSDB limit for OSPF. If the value is -1, then
there is no limit. When the number of non-default AS-external-LSAs in a router's link-
state database reaches the external LSDB limit, the router enters overflow state. The
router never holds more than the external LSDB limit non-default AS-external-LSAs
in it database. The external LSDB limit MUST be set identically in all routers attached
to the OSPF backbone and/or any regular OSPF area. The range for limit is -1 to
2147483647.
Default
-1
Format
external-lsdb-limit
Mode Router OSPF Config