Kontron AT8901M CLI - Manual (Page 232)

Utility Commands AT8901M
AT8901M CLI Reference Manual Page 5 - 32
Port
Server Port Number
Last Attempt Time
Last server attempt time for the specified server.
Last Update Status
Last server attempt status for the server.
Total Unicast Requests
Number of requests to the server.
Failed Unicast Requests
Number of failed requests from server.
5.8 DHCP Server Commands
This section describes the commands you to configure the DHCP server settings for the
switch. DHCP uses UDP as its transport protocol and supports a number of features
that facilitate in administration address allocations.
5.8.1 ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters
DHCP pool configuration mode.
Default
none
Format
ip dhcp pool
Mode
Global Config
5.8.1.1 no ip dhcp pool
This command removes the DHCP address pool. The name should be previously
configured pool name.
Format
no ip dhcp pool
Mode
Global Config
5.8.2 client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a
valid notation in hexadecimal format. In some systems, such as Microsoft DHCP
clients, the client identifier is required instead of hardware addresses. The unique-
identifier is a concatenation of the media type and the MAC address. For example, the
Microsoft client identifier for Ethernet address c819.2488.f177 is 01c8.1924.88f1.77
where 01 represents the Ethernet media type. For more information, refer to the
“Address Resolution Protocol Parameters” section of RFC 1700, Assigned Numbers
for a list of media type codes.
Default
none
Format
client-identifier
Mode
DHCP Pool Config
5.8.2.1 no client-identifier
This command deletes the client identifier.
Format
no client-identifier
Mode
DHCP Pool Config