Kontron AT8901M CLI - Manual (Page 54)

Switching Commands AT8901M
AT8901M CLI Reference Manual Page 2 - 18
2.3.3 vlan
This command creates a new VLAN and assigns it an ID. The ID is a valid VLAN
identification number (ID 1 is reserved for the default VLAN). VLAN range is 2-4094.
Format
vlan <2-4094>
Mode VLAN Config
2.3.3.1 no vlan
This command deletes an existing VLAN. The ID is a valid VLAN identification
number (ID 1 is reserved for the default VLAN). The VLAN range is 2-4094.
Format
no vlan <2-4094>
Mode VLAN Config
2.3.4 vlan acceptframe
This command sets the frame acceptance mode per interface. For VLAN Only mode,
untagged frames or priority frames received on this interface are discarded. For Admit
All mode, untagged frames or priority frames received on this interface are accepted
and assigned the value of the interface VLAN ID for this port. With either option,
VLAN tagged frames are forwarded in accordance with the IEEE 802.1Q VLAN
Specification.
Default all
Format
vlan acceptframe {vlanonly | all}
Mode Interface Config
2.3.4.1 no vlan acceptframe
This command sets the frame acceptance mode per interface to Admit All. For Admit
All mode, untagged frames or priority frames received on this interface are accepted
and assigned the value of the interface VLAN ID for this port. With either option,
VLAN tagged frames are forwarded in accordance with the IEEE 802.1Q VLAN
Specification.
Format
vlan acceptframe {vlanonly | all}
Mode Interface Config
2.3.5 vlan ingressfilter
This command enables ingress filtering. If ingress filtering is disabled, frames received
with VLAN IDs that do not match the VLAN membership of the receiving interface
are admitted and forwarded to ports that are members of that VLAN.
Default disabled
Format
vlan ingressfilter
Mode Interface Config