7 cli command logging command, 1 logging cli-command, 8 radius commands – Kontron AT8901M CLI User Manual
Page 275: 1 radius accounting mode, 2 radius server host, 7 cli command logging command - 23, Logging cli-command - 23, 8 radius commands - 23, Radius accounting mode - 23, Radius server host - 23
AT8901M
Management Commands
Page 6 - 23
AT8901M CLI Reference Manual
DVMRP Traps
Can be enabled or disabled. The factory default is disabled. Indicates
whether DVMRP traps are sent.
OSPF Traps
Can be enabled or disabled. The factory default is disabled. Indicates
whether OSPF traps are sent.
PIM Traps
Can be enabled or disabled. The factory default is disabled. Indicates
whether PIM traps are sent.
6.7
CLI Command Logging Command
This section describes the commands you use to configure CLI Command Logging.
6.7.1
logging cli-command
This command enables the CLI command logging feature, which enables the
FASTPATH software to log all CLI commands issued on the system.
Default
enabled
Format
logging cli-command
Mode
Global Config
6.7.1.1
no logging cli-command
This command disables the CLI command Logging feature.
Format
no logging cli-command
Mode
Global Config
6.8
RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for
authentication and accounting.
6.8.1
radius accounting mode
This command is used to enable the RADIUS accounting function.
Default
disabled
Format
radius accounting mode
Mode
Global Config
6.8.1.1
no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e.
the RADIUS accounting function is disabled.
Format
no radius accounting mode
Mode
Global Config
6.8.2
radius server host
This command is used to configure the RADIUS authentication and accounting server.
If you use the