Kontron AT8901M CLI - Manual (Page 272)

Management Commands AT8901M
AT8901M CLI Reference Manual Page 6 - 20
Default snmpv2
Format
snmptrap
[snmpversion ]
Mode Global Config
6.6.14.1 no snmptrap
This command deletes trap receivers for a community.
Format
no snmptrap
Mode Global Config
6.6.15 snmptrap snmpversion
This command modifies the SNMP version of a trap. The maximum length of
is 16 case-sensitive alphanumeric characters. The parameter options
are snmpv1 or snmpv2.
NOTE: This command does not support a “no” form.
Default snmpv2
Format
snmptrap snmpversion
Mode Global Config
6.6.16 snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum
length of name is 16 case-sensitive alphanumeric characters.
NOTE: IP addresses in the SNMP trap receiver table must be unique. If you
make multiple entries using the same IP address, the first entry is
retained and processed. All duplicate entries are ignored.
Format
snmptrap ipaddr
Mode Global Config
6.6.17 snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active
(able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
snmptrap mode
Mode Global Config
6.6.17.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive
traps.
Format
no snmptrap mode
Mode Global Config
6.6.18 snmp trap link-status
This command enables link status traps by interface.