Kontron AT8901M CLI - Manual (Page 136)

Routing Commands AT8901M
AT8901M CLI Reference Manual Page 3 - 22
Administrative Mode The status (Enable or Disable) of the specific router.
State
The state (Master/backup) of the virtual router.
3.5.12 show ip vrrp interface brief
This command displays information about each virtual router configured on the
FASTPATH switch. This command takes no options. It displays information about
each virtual router.
Format
show ip vrrp interface brief
Modes Privileged EXEC
User EXEC
Interface Valid slot and port number separated by forward slashes.
VRID The router ID of the virtual router.
IP Address The virtual router IP address.
Mode Indicates whether the virtual router is enabled or disabled.
State The state (Master/backup) of the virtual router.
3.6 DHCP and BOOTP Relay Commands
This section describes the commands you use to configure BootP/DHCP Relay on the
switch. A DHCP relay agent operates at Layer 3 and forwards DHCP requests and
replies between clients and servers when they are not on the same physical subnet.
3.6.1 bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the
system.
Default
disabled
Format
bootpdhcprelay cidoptmode
Mode Global Config
3.6.1.1 no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the
system.
Format
no bootpdhcprelay cidoptmode
Mode Global Config
3.6.2 bootpdhcprelay enable
This command enables the forwarding of relay requests for BootP/DHCP Relay on the
system.
Default
disabled
Format
bootpdhcprelay enable
Mode Global Config