Kontron AT8901M CLI - Manual (Page 56)

Switching Commands AT8901M
AT8901M CLI Reference Manual Page 2 - 20
auto The interface is dynamically registered in this VLAN by GVRP. The
interface will not participate in this VLAN unless a join request is
received on this interface. This is equivalent to registration normal.
2.3.9 vlan participation all
This command configures the degree of participation for all interfaces in a VLAN. The
ID is a valid VLAN identification number. You can use the following participation
options:
• include—The interface is always a member of this VLAN. This is equivalent to
registration fixed.
• exclude—The interface is never a member of this VLAN. This is equivalent to reg-
istration forbidden.
• auto—The interface is dynamically registered in this VLAN by GVRP. The inter-
face will not participate in this VLAN unless a join request is received on this
interface. This is equivalent to registration normal.
Format
vlan participation all {exclude | include | auto} <1-4094>
Mode Global Config
2.3.10 vlan port acceptframe all
This command sets the frame acceptance mode for all interfaces. The modes defined as
follows:
• VLAN Only mode - Untagged frames or priority frames received on this interface
are discarded.
• Admit All mode - Untagged frames or priority frames received on this interface are
accepted and assigned the value of the interface VLAN ID for this port.
With either option, VLAN tagged frames are forwarded in accordance with the IEEE
802.1Q VLAN Specification.
Default all
Format
vlan port acceptframe all {vlanonly | all}
Mode Global Config
2.3.10.1 no vlan port acceptframe all
This command sets the frame acceptance mode for all interfaces to Admit All. For
Admit All mode, untagged frames or priority frames received on this interface are
accepted and assigned the value of the interface VLAN ID for this port. With either
option, VLAN tagged frames are forwarded in accordance with the IEEE 802.1Q
VLAN Specification.
Format
no vlan port acceptframe all
Mode Global Config
2.3.11 vlan port ingressfilter all
This command enables ingress filtering for all ports. If ingress filtering is disabled,
frames received with VLAN IDs that do not match the VLAN membership of the