Kontron AT8901M CLI - Manual (Page 163)

AT8901M Routing Commands
Page 3 - 49 AT8901M CLI Reference Manual
Format
no auto-summary
Mode Router RIP Config
3.8.5 default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
default-information originate
Mode Router RIP Config
3.8.5.1 no default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
no default-information originate
Mode Router RIP Config
3.8.6 default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
Format
default-metric <
0-15
>
Mode Router RIP Config
3.8.6.1 no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default
value.
Format
no default-metric
Mode Router RIP Config
3.8.7 distance rip
This command sets the route preference value of RIP in the router. Lower route
preference values are preferred when determining the best route. A route with a
preference of 255 cannot be used to forward traffic.
Default
15
Format
distance rip <
1-255
>
Mode Router RIP Config
3.8.7.1 no distance rip
This command sets the default route preference value of RIP in the router.
Format
no distance rip
Mode Router RIP Config
3.8.8 distribute-list out (RIP)
This command is used to specify the access list to filter routes received from the source
protocol.