Kontron AT8901M CLI - Manual (Page 262)

Management Commands AT8901M
AT8901M CLI Reference Manual Page 6 - 10
Session Time Total time this session has been connected.
6.3.11 show telnet
This command displays the current outbound Telnet settings. In other words, these
settings apply to Telnet connections initiated from the switch to a remote system.
Format
show telnet
Modes Privileged EXEC
User EXEC
Outbound Telnet Login Timeout The number of minutes an outbound Telnet session
is allowed to remain inactive before being logged off.
Maximum Number of Outbound Telnet Sessions The number of simultaneous out-
bound Telnet connections allowed.
Allow New Outbound Telnet Sessions Indicates whether outbound Telnet sessions
will be allowed.
6.3.12 show telnetcon
This command displays the current inbound Telnet settings. In other words, these
settings apply to Telnet connections initiated from a remote system to the switch.
Format
show telnetcon
Modes Privileged EXEC
User EXEC
Remote Connection Login Timeout (minutes) This object indicates the number of
minutes a remote connection session is allowed to remain inactive
before being logged off. May be specified as a number from 1 to 160.
The factory default is 5.
Maximum Number of Remote Connection Sessions This object indicates the num-
ber of simultaneous remote connection sessions allowed. The factory
default is 5.
Allow New Telnet Sessions New Telnet sessions will not be allowed when this field
is set to no. The factory default value is yes.
6.4 Secure Shell (SSH) Command
This section describes the commands you use to configure SSH access to the switch.
Use SSH to access the switch from a remote management host.
NOTE: The system allows a maximum of 5 SSH sessions.
6.4.1 ip ssh
Use this command to enable SSH access to the system.
Default disabled
Format
ip ssh
Mode Privileged EXEC