44 show ip ospf database, 44 show ip ospf database - 40, Routing commands at8901m – Kontron AT8901M CLI User Manual
Page 154
Routing Commands
AT8901M
AT8901M CLI Reference Manual
Page 3 - 40
Default Metric The metric value for the default route advertised into the NSSA.
Default Metric Type The metric type for the default route advertised into the NSSA.
Translator Role The NSSA translator role of the ABR, which is always or candidate.
Translator Stability Interval The amount of time that an elected translator continues
to perform its duties after it determines that its translator status has
been deposed by another router.
Translator State Shows whether the ABR translator state is disabled, always, or
elected.
3.7.44
show ip ospf database
This command displays information about the link state database when OSPF is
enabled. If you do not enter any parameters, the command displays the LSA headers
for all areas. Use the optional
parameter to display database information
about a specific area. Use the optional parameters to specify the type of link state
advertisements to display. Use
asbr-summary
to show the autonomous system
boundary router (ASBR) summary LSAs. Use
external
to display the external LSAs.
Use
network
to display the network LSAs. Use
nssa-external
to display NSSA
external LSAs. Use
router
to display router LSAs. Use
summary
to show the LSA
database summary information. Use
to specify the link state ID (LSID). The
value of
can be an IP address or an integer in the range of 0-4294967295. Use
adv-router
to show the LSAs that are restricted by the advertising router. Use
self-
originate
to display the LSAs in that are self originated. The information below is
only displayed if OSPF is enabled.
Format
show ip ospf
[
database
[{asbr-summary | external |
network | nssa-external | router | summary}] [
[
Modes
Privileged EXEC
User EXEC
For each link-type and area, the following information is displayed.
Link Id
A number that uniquely identifies an LSA that a router originates from
all other self originated LSAs of the same LS type.
Adv Router The Advertising Router. Is a 32 bit dotted decimal number represent-
ing the LSDB interface.
Age
A number representing the age of the link state advertisement in sec-
onds.
Sequence
A number that represents which LSA is more recent.
Checksum
The total number LSA checksum.
Options
This is an integer. It indicates that the LSA receives special handling
during routing calculations.
Rtr Opt
Router Options are valid for router links only.