Kontron AT8901M CLI - Manual (Page 270)

Management Commands AT8901M
AT8901M CLI Reference Manual Page 6 - 18
Default disabled
Format
snmp-server enable traps violation
Mode Interface Config
6.6.8.1 no snmp-server enable traps violation
This command disables the sending of new violation traps.
Format
no snmp-server enable traps violation
Mode Interface Config
6.6.9 snmp-server enable traps
This command enables the Authentication Flag.
Default enabled
Format
snmp-server enable traps
Mode Global Config
6.6.9.1 no snmp-server enable traps
This command disables the Authentication Flag.
Format
no snmp-server enable traps
Mode Global Config
6.6.10 snmp-server enable traps bcaststorm
This command enables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is
enabled.
Default enabled
Format
snmp-server enable traps bcaststorm
Mode Global Config
6.6.10.1 no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is
enabled.
Format
no snmp-server enable traps bcaststorm
Mode Global Config
6.6.11 snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link
traps are sent only if the Link Trap flag setting associated with the port is enabled.
“snmp trap link-status” on page 6 - 20.
Default enabled
Format
snmp-server enable traps linkmode
Mode Global Config