Kontron AT8901M CLI - Manual (Page 131)

AT8901M Routing Commands
Page 3 - 17 AT8901M CLI Reference Manual
Mode VLAN Config
3.4.2 show ip vlan
This command displays the VLAN routing information for all VLANs with routing
enabled.
Format
show ip vlan
Modes Privileged EXEC
User EXEC
MAC Address used by Routing VLANs The MAC Address associated with the
internal bridge-router interface (IBRI). The same MAC Address is
used by all VLAN routing interfaces. It will be displayed above the
per-VLAN information.
VLAN ID The identifier of the VLAN.
Logical Interface The logical slot/port associated with the VLAN routing interface.
IP Address
The IP address associated with this VLAN.
Subnet Mask The subnet mask that is associated with this VLAN.
3.5 Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router
Redundancy Protocol (VRRP) and to view VRRP status information. VRRP helps
provide failover and load balancing when you configure two devices as a VRRP pair.
3.5.1 ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP
on the router.
Default
none
Format
ip vrrp
Mode Global Config
3.5.1.1 no ip vrrp
Use this command in Global Config mode to disable the default administrative mode
of VRRP on the router.
Format
no ip vrrp
Mode Global Config
3.5.2 ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with
the interface. The parameter is the virtual router ID, which has an integer value
range from 1 to 255.
Format
ip vrrp
Mode Interface Config