Kontron AT8901M CLI - Manual (Page 266)

Management Commands AT8901M
AT8901M CLI Reference Manual Page 6 - 14
6.5.3.1 no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified user as readwrite
for the “admin” user and readonly for all other users. The value is the
user name for which the specified access mode will apply.
Format
no users snmpv3 accessmode
Mode Global Config
6.5.4 users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified user. The valid
authentication protocols are none, md5 or sha.
If you specify
md5
or
sha
, the login password
is also used as the snmpv3 authentication password and therefore must be at least eight
characters in length. The is the user name associated with the
authentication protocol. You must enter the in the same case you used
when you added the user. To see the case of the , enter the
show users
command.
Default no authentication
Format
users snmpv3 authentication
{none | md5 | sha}
Mode Global Config
6.5.4.1 no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified user to
none. The is the user name for which the specified authentication
protocol is used.
Format
no users snmpv3 authentication
Mode Global Config
6.5.5 users snmpv3 encryption
This command specifies the encryption protocol used for the specified user. The valid
encryption protocols are
des
or
none.
If you select
des
, you can specify the required key on the command line. The
encryption key must be 8 to 64 characters long. If you select the
des
protocol but do
not provide a key, the user is prompted for the key. When you use the
des
protocol, the
login password is also used as the snmpv3 encryption password, so it must be a
minimum of eight characters. If you select
none
, you do not need to provide a key.
The value is the login user name associated with the specified encryption.
You must enter the in the same case you used when you added the user.
To see the case of the , enter the
show users
command.
Default no encryption
Format
users snmpv3 encryption
{none | des[key]}
Mode Global Config
6.5.5.1 no users snmpv3 encryption
This command sets the encryption protocol to none. The is the login user
name for which the specified encryption protocol will be used.