Kontron AT8901M CLI - Manual (Page 181)

AT8901M Quality of Service (QoS) Commands
Page 4 - 13 AT8901M CLI Reference Manual
4.3.15 match source-address mac
This command adds to the specified class definition a match condition based on the
source MAC address of a packet. The > parameter is any layer 2 MAC address
formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,
00:11:22:dd:ee:ff). The > parameter is a layer 2 MAC address bit mask,
which may not be contiguous, and is formatted as six, two-digit hexadecimal numbers
separated by colons (e.g., ff:07:23:ff:fe:dc).
NOTE: This command is not available on the Broadcom 5630x platform.
Default none
Format
match source-address mac
Mode Class-Map Config
4.3.16 match srcip
This command adds to the specified class definition a match condition based on the
source IP address of a packet. The
parameter specifies an IP address. The
parameter specifies an IP address bit mask and must consist of a contiguous
set of leading 1 bits.
Default none
Format
match srcip
Mode Class-Map Config
4.3.17 match srcl4port
This command adds to the specified class definition a match condition based on the
source layer 4 port of a packet using a single keyword or numeric notation. To specify
the match condition as a single keyword notation, the value for
is one of the
supported port name keywords (listed below). The currently supported
values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www . Each of these translates
into its equivalent port number, which is used as both the start and end of a port range.
To specify the match condition as a numeric value, one layer 4 port number is required.
The port number is an integer from 0 to 65535.
Default none
Format
match srcl4port { | <0-65535>}
Mode Class-Map Config
4.3.18 match vlan
This command adds to the specified class definition a match condition based on the
value of the layer 2 VLAN Identifier field (the only tag in a single tagged packet or the
first or outer tag of a double VLAN tagged packet). The VLAN ID is an integer from 1
to 4095.
NOTE: This command is not available on the Broadcom 5630x platform.
Default none
Format
match vlan <1-4095>