Kontron AT8901M CLI - Manual (Page 230)

Utility Commands AT8901M
AT8901M CLI Reference Manual Page 5 - 30
Format
no sntp unicast client poll-timeout
Mode
Global Config
5.7.6 sntp unicast client poll-retry
This command will set the poll retry for SNTP unicast clients to a value from 0 to 10.
Default
1
Format
sntp unicast client poll-retry
Mode
Global Config
5.7.6.1 no sntp unicast client poll-retry
This command will reset the poll retry for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-retry
Mode
Global Config
5.7.7 sntp multicast client poll-interval
This command will set the poll interval for SNTP multicast clients in seconds as a
power of two where
can be a value from 6 to 16.
Default
6
Format
sntp multicast client poll-interval
Mode
Global Config
5.7.7.1 no sntp multicast client poll-interval
This command resets the poll interval for SNTP multicast clients to its default value.
Format
no sntp multicast client poll-interval
Mode
Global Config
5.7.8 sntp server
This command configures an SNTP server (a maximum of three). The optional priority
can be a value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
Format
sntp server [ [
[]]]
Mode
Global Config
5.7.8.1 no sntp server
This command deletes an server from the configured SNTP servers.
Format
no sntp server remove
Mode
Global Config
5.7.9 show sntp
This command is used to display SNTP settings and status.