Kontron AT8901M CLI - Manual (Page 206)

Utility Commands AT8901M
AT8901M CLI Reference Manual Page 5 - 6
5.2.8 show atca ekeying
This command displays the current ekeying status together with admin mode and link
status for all interfaces. For uplink interfaces no ekeying state is displayed.
Format
show atca ekeying all
Mode
Privileged EXEC
5.3 System Information and Statistics Commands
This section describes the commands you use to view information about system
features, components, and configurations.
5.3.1 show arp switch
This command displays the contents of the IP stack’s Address Resolution Protocol
(ARP) table. The IP stack only learns ARP entries associated with the management
interfaces - network or service ports. ARP entries associated with routing interfaces are
not listed.
Format
show arp switch
Mode
Privileged EXEC
IP Address
IP address of the management interface or another device
on the management network.
MAC Address
Hardware MAC address of that device.
Interface
For a service port the output is Management. For a network
port, the output is the slot/port of the physical inter-
face.
5.3.2 show eventlog
This command displays the event log, which contains error messages from the system.
The event log is not cleared on a system reset.
Format
show eventlog
Mode
Privileged EXEC
File
The file in which the event originated.
Line
The line number of the event
Task Id
The task ID of the event.
Code
The event code.
Time
The time this event occurred.
NOTE: Event log information is retained across a switch reset.
5.3.3 show hardware
This command displays inventory information for the switch.
NOTE: The
show version
command and the
show hardware
command dis-
play the same information. In future releases of the software, the
show