Kontron AT8901M CLI - Manual (Page 261)

AT8901M Management Commands
Page 6 - 9 AT8901M CLI Reference Manual
6.3.7.1 no telnetcon maxsessions
This command sets the maximum number of Telnet connection sessions that can be
established to the default value.
Format
no telnetcon maxsessions
Mode Privileged EXEC
6.3.8 telnetcon timeout
This command sets the Telnet connection session timeout value, in minutes. A session
is active as long as the session has not been idle for the value set. The time is a decimal
value from 1 to 160.
NOTE: When you change the timeout value, the new value is applied to all
active and inactive sessions immediately. Any sessions that have been
idle longer than the new timeout value are disconnected immediately.
Default 5
Format
telnetcon timeout
<1-160>
Mode Privileged EXEC
6.3.8.1 no telnetcon timeout
This command sets the Telnet connection session timeout value to the default.
NOTE: Changing the timeout value for active sessions does not become effec-
tive until the session is reaccessed. Also, any keystroke activates the
new timeout duration.
Format
no telnetcon timeout
Mode Privileged EXEC
6.3.9 disconnect
Use the
disconnect
command to close Telnet or SSH sessions. Use all to close all
Telnet and SSH sessions, or use to specify the session ID to close. To
view the possible values for , use the
show loginsession
command.
Format
disconnect
{ | all}
Mode Privileged EXEC
6.3.10 show loginsession
This command displays current Telnet and serial port connections to the switch.
Format
show loginsession
Mode Privileged EXEC
ID Login Session ID
User Name The name the user will use to login using the serial port or Telnet.
Connection From IP address of the Telnet client machine or EIA-232 for the serial
port connection.
Idle Time Time this session has been idle.