Kontron AT8901M CLI - Manual (Page 164)

Routing Commands AT8901M
AT8901M CLI Reference Manual Page 3 - 50
Default 0
Format
distribute-list
<1-199>
out
{ospf | static | connected}
Mode Router RIP Config
3.8.8.1 no distribute-list out
This command is used to specify the access list to filter routes received from the source
protocol.
Format
no distribute-list
<1-199>
out
{ospf | static | connected}
Mode Router RIP Config
3.8.9 ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified
interface. The value of <
type
> is either
none
,
simple
, or
encrypt
. The value for
authentication key [
key
] must be 16 bytes or less. The [
key
] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the
value of <
type
> is
encrypt
, a keyid in the range of 0 and 255 must be specified .
Unauthenticated interfaces do not need an authentication key or authentication key ID.
Default none
Format
ip rip authentication
{none | {simple } | {encrypt
}}
Mode Interface Config
3.8.9.1 no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
Format
no ip rip authentication
Mode Interface Config
3.8.10 ip rip receive version
This command configures the interface to allow RIP control packets of the specified
version(s) to be received.
The value for <
mode
> is one of:
rip1
to receive only RIP version 1 formatted packets,
rip2
for RIP version 2,
both
to receive packets from either format, or
none
to not
allow any RIP control packets to be received.
Default
both
Format
ip rip receive version
{rip1 | rip2 | both | none}
Mode Interface Config
3.8.10.1 no ip rip receive version
This command configures the interface to allow RIP control packets of the default
version(s) to be received.
Format
no ip rip receive version
Mode Interface Config